|
This is a flower
pot stand perfect for a plant or as a table center containing dry
flowers. The mounting system is very easy, once the pieces of the
frame have been glued, the sides are encased and glued in position
without slots. The pieces have been designed in the computer with
total precision for a straightforward mounting.
This flower pot
stand is designed preferably for 1/4 and 1/8 inches wood or for 6
and 3 mm wood. Of course
it can be scaled up or down to obtain different results. The
following table gives the dimensions of the stand depending on the wood thickness you use:
|
Height |
Width |
|
1/4 and 1/8 in. wood |
10,4 in. |
11
in. |
|
6 and 3 mm wood |
24.9 cm |
26.3 cm |
Please note that this pattern is registered and copyrighted. If you would like to have it I offer it for 8 € plus shipping.
The pattern is computer made, which provides total precision, and nicely printed for convenient scrolling. Please write me to
[email protected] to buy this pattern or for any questions.
These pictures have been kindly sent
by Aravamudhan Rajagopalan from Tamil Nadu, India. The pot stand shown is made of teak and red wood hardwood. |
