Finescrollsaw

023 - Toulouse clock

This is a quite simple and at the same time interesting clock. This pattern is based in an old French design that I have restored carefully in the computer. All the visible edges (except the rear ones) are formed by beveled sides, so that when completed there are no visible joint slots. Mounting the clock is straightforward thanks to three frame pieces inside the lower section.

The clock is designed to be made preferably with 1/4 inches wood or with 6 mm wood, but of course other wood thickness can be used scaling the pattern. The following table gives the dimensions of the clock depending on the wood thickness you use:

	Clock height	Clock width
1/4 in. wood	13,9 in.	9,7 in.
6 mm wood	33.2 cm	23.2 cm

Please note that this pattern is registered and copyrighted. If you would like to have it I offer it for € plus shipping. The pattern is computer made, which provides total precision, and nicely printed for convenient scrolling. Please write me to info@finescrollsaw.com to buy this pattern or for any questions.

These pictures have kindly been sent by Valeriy Elizarov from Vilyuchinsk, Russia.


This picture is courtesy of Ester and Isaac Arditi from Israel: "The result of your patterns are so nice we don't know which model is nicer, all of them look marvelous".	This picture has been sent by Santiago Fernandez from Barcelona, Spain.

These pictures are courtesy of Francisco Rodríguez from Manzanares, Ciudad Real, Spain. Note that the upper border is an addition of the crafter, not included in the original pattern.


This picture has been sent by Jose Luis Tellez from Celaya (Guanajuato, Mexico).	Picture courtesy of Daniel Caruana from Malta.

These pictures have been kindly sent by Xavier Benedi from Cornellà de Llobregat, Spain.